54
GB
C1
C2
C3
C4
step 3 feed the fixing clamp through the slot below the holder socket, pass the clamp
around the handlebar and tighten it with a small screw driver. Do not overtighten, the
plastic screw might be damaged. Readjust the cable so that it will not be stretched
during steering. Finally tighten the zip ties holding the sensor.
2.3 Battery Installation (computer)
Your VDO computer comes with a 3 V battery (type 2032).
step 1 insert the battery into the computer, positive pole face-up
step 2 watch out not to edge over the battery
step 3 watch out that the rubber washer lies levelled on the inside
of the battery compartment.
step 4 insert the battery door into the opening, twist it with a coin
to the right until the stop after approx. 1/3 turn.
Battery Change
TIP: VDO recommends an annual battery change. Buy the spare battery from your Bike Shop
>>> P04
To Next Page
Loading...
