Switching on / off
The navigation computer is switched on and off together with the ignition.
☞
Switch on the ignition.
:
As soon as the navigation system is operational, an instruction about using the
system appears in the display.
☞
Read this instruction and confirm it by pressing the OK button on the remote
control.
:
The Start Menu appears.
■
Stand-by mode
You can switch the system into stand-by mode as follows:
☞
Select “Stand-by” in the Start Menu.
:
The display and the audible guidance messages are deactivated.
☞
Press one of the cursor buttons 4, 6, 8, 2 or the OK button on the remote control
to exit stand-by mode again.
✎
If an external speaker is connected, in standby mode you will continue to hear the
audible information.
If you do not wish to hear the audible information, select “Stop guidance” before
switching the system into stand-by mode.
✎
If the navigation system is switched off in stand-by mode, it restarts in stand-by
mode when the ignition is switched on again.
■ Shutdown delay time
Immediately after switching off the ignition, the monitor is deactivated, but the
navigation computer remains active for a period that can be set. This has the
advantage that you can continue the directional guidance after a short stop (e.g. at
the petrol station), without the navigation computer having to calculate the route
again.
The shutdown delay time can be set between 1 and 10 minutes in the “Settings –>
General settings –> Shut-down timer” menu. See page 36.
Volume adjustment
You can set the volume of the audible guidance messages as follows:
☞
Press the V button once or several times to increase the volume of the audible
messages.
☞
Press the W button once or several times to decrease the volume of the audible
messages.
Operation
8