Vdwall LVP615U - Page 35

LVP615U 使用说明
35
port to YPbPr.
Operation steps
：
In the menu of 2.5 V2 or YPbPr，rotate knob to select needed
parameters and press “OK” to make them effective.
6.2.4 Signal switch mode
Press Setup to enter setup menu
，
press ↓ to select “2. Input video
signal”，Then press OK to enter“2.input video signal ”，and press ↓ to
select signal switch mode“one key switch ”or Pre.+Take
switch ”,Press OK to apply.
2.Input video signal
--------------------------------------
2.1 DVI EDID 1280x1024_60
2.2 V1/V2 backup off
2.3 VGA1/VGA2 backup off
2.4 HDMI/DVI backup off
2.5 V2 or YPbPr V2
2.6 switch mode Pre.+Take SW. ？