TCI-W13, TCI-W23 Universal Controller
OVERVIEW
Doc: 70-00-0365, V1.0, 20200304 © Vector Controls GmbH, Switzerland Page 1
Subject to alteration
TCI-W13, TCI-W23 Series wall mounted universal controller
Features
• Universal PI and/or binary control for any analog
input/output signal and range
• Multiple auxiliary functions: heat-cool auto changeover,
automatic enable, set point compensation
• Differential, averaging, min and max functions
• Cascading of control loops (-W23 type)
• Alarm monitoring of low and high limits on all inputs
• Programmable reaction in case of alarm
• Feedback function for inputs and set points
• Functions for dehumidifying, set point shift, cascade control
• Password protected programmable user and control
parameters
TCI-W23 also includes
• Power cap protected real-time clock with 48 hr power backup
• 7-day programmable schedules, with options including
change of set points and direct position of manual outputs
• Blue backlight
• Fan coil units
• Heat exchangers
• Zoning
• VAV
• Air handlers
• Fan, pump control
• Humidifiers
• Dehumidifiers
• Ventilation
• Radiant heating
• Radiant cooling
• Pressurization
General
• TCI-W13: 1 independent control loop, 1 internal temperature sensor, 1 universal input (analog/binary/temp),
1 binary output, 2 analog outputs
• TCI-W23: 2 independent control loops, 1 internal temperature sensor, 1 universal input, 1 passive input,
1 binary output, 2 analog outputs.
• Internal temperature sensor standard. Add replaceable humidity element as required or order -H version:
AES3-HT-A2 (2%), AES3-HT-A3 (3%) or AES3-HT-A5 (5%)
• Flexible application configuration is made with a parameter-setting routine using the standard operation terminal
Name
Ordering
Temperature sensors: Use Vector Controls NTC sensors to achieve maximum accuracy: SDB-Tn10-20 (duct), SRA-Tn10
(room), SDB-Tn10-20 + AMI-S10 as immersion sensor.
Actuators: Choose modulating actuators with an input signal type of 0…10 V DC or 4…20 mA (min. and max. signal
limitations may be set with parameters. 3-point point actuators with constant running time are recommended).
Binary auxiliary devices (e.g. pumps, fans, on/off valves, humidifiers, etc.): Do not directly connect devices that
exceed specified limits in technical specifications – observe startup current on inductive loads.
Housing Blank = square housing
In/Outputs:
Control loops: 1 = 1 control loop, 2 = 2 control loops
Mounting: W = Wall mounted
Series: TCI