Page 31
TO STOP A PLLD TEST
In the Operating mode, press Function until you see the message:
Press Step. The display reads:
Press Enter to stop the test on all lines, or press Change and the dis-
play reads:
Press Enter to stop the test on the line shown, or press Change until
you see the line you want to select, then press Enter. The system
stops the test and displays the status message:
STOP LINE PRESSURE TEST
PRESS <STEP> TO CONTINUE
STOP LINE TEST: LINE (#)
PRESS <ENTER>
Q#: TEST ABORTED
PRESS <STEP> TO CONTINUE
TO PRINT ALL PLLD TEST RESULTS
In the Operating mode, press Function until you see the display
below then press Print:
PRESSURE LINE RESULTS
PRESS <STEP> TO CONTINUE
To Next Page
Loading...
