Special Mag Probe Installation Kits Chem-ISO kit
22
Chem-ISO kit
This probe kit is intended to be installed in a tank that has a threaded 2” NPT opening to accept the probe and
connectors.
The parts listed in Table 5 and shown in Figure 15 below are included in the Installation kit (
P/N 331824-000)
and are required to install a Veeder-Root Form No. 8463 Series Mag Probe into a tank.
Figure 15. Mag Plus Probe Chem-ISO Kit
Table 5. Chem-ISO Kit, P/N 331824-000
Qty. Part Description Part No.
1 Tube group 331800-XXX
1 Float/Magnet group 331823-001
1 Male connector 7/8” tube to 1” NPT 576008-643
1 Reduction bushing 2” NPT to 1” NPT 576008-645
1 Float retaining ring 511805-378
1 Cable 330272-XXX
1
Cable Seal Kit (cord grip fitting, sealant pack,
wire nuts, and tie wraps) 330020-067
1 Rain shield 331880-001
Stainless steel tube
0.875" OD x ordered
length
Retaining ring
SS float
Magnet end has Top
etched on surface
Reduction
bushing
2" NPT
to 1" NPT
probes\ssfltkit.eps
Tie wraps (CSK) Epoxy sealant (CSK)
Wire nuts (CSK)
Cord Grip Fitting (CSK)
Note: watch
orientation of
bushing when
assembling
the cord grip
(taper down)
Body
1/2"-14 NPT
threads
1/2"-14 NPSL
threads
Cord Grip
Nut
Bushing
.4"
.6"
Cable Seal Kit
TOP
Rear Ferrule
Front Ferrule
Male connector
7/8" tube
to 1" NPT
Gland Nut
Rain Shield
To Next Page
Loading...
Need help?
General
