Special Mag Probe Installation Kits LPG-ISO kit
23
LPG-ISO kit
This probe kit is intended to be installed in a tank that has a threaded 1-1/2” NPT opening to accept the probe
and connectors. The threaded opening must meet local codes for pressure vessels.
The parts listed in Table 6 and shown in Figure 16 below are included in the installation kit (
P/N 331807-000)
and are required to install a Veeder-Root Form No. 8463 Series Mag Probe into a liquefied petroleum gas (LPG)
tank.
Figure 16. Mag Plus Probe LPG-ISO Kit
Table 6. LPG-ISO Kit, P/N 331807-000
Qty. Part Description Part No.
1 Tube group 331800-XXX
1 Float/Magnet group 331797-001
1 Male connector 7/8” tube to 1” NPT 576008-643
1 Reduction bushing 1-1/2” NPT to 1” NPT 576008-644
1 Float retaining ring 511805-378
1 Cable 330272-XXX
1
Cable Seal Kit (cord grip fitting, sealant pack,
wire nuts, and tie wraps) 330020-067
1 Rain shield 331880-001
1 Warning tag 331879-001
Stainless steel tube
7/8" OD x ordered
length
Retaining ring
Float
Magnet end
(up)
probes\lpgtubekit.eps
Tie wraps (CSK) Epoxy sealant (CSK)
Wire nuts (CSK)
Cord Grip Fitting (CSK)
Note: watch
orientation of
bushing when
assembling
the cord grip
(taper down)
Body
1/2"-14 NPT
threads
1/2"-14 NPSL
threads
Cord Grip
Nut
Bushing
.4"
.6"
Cable Seal Kit
Reduction bushing
1-1/2" to 1" NPT or
2" NPT to 1" NPT
(see kits above)
Male connector
7/8" tube
to 1" NPT
Rear Ferrule
Front Ferrule
Gland Nut
Rain Shield
To Next Page
Loading...
Need help?
General
