ISD Reports Viewing ISD Reports via RS-232 Connection
42
Assist Systems - Hose No Test Result
• If the Degradation test did not run and the Gross test did not run, then an N is posted.
• If there were no events received to make any conclusion about the A/L value for the hose, the A/L value is
replaced with N.
• If there are some events received, enough to calculate an average, but not enough to complete a test, the No
Test result will appear with an A/L average.
Assist Systems - Hose Pass Result
• When none of the above results W,F,G,D,N appear then it is a pass.
• If the Degradation test did not run (no test), but the Gross test passed, the result is a PASS.
• If the Gross test did not run (no test), but the Degradation test passed, the result is a PASS.
Assist Systems - Code Precedent (listed high to low)
1. G, F - Gross Failure (A/L) and Gross Stat Failure (BLKD)
2. D - Degradation Failure (A/L)
3. W - Gross Warning (A/L) and Gross Stat Warning (BLKD)
4. W - Degradation Warning (A/L)
5. PASS - Pass Gross and/or Degradation test.
6. N - No Test - Neither Gross nor Degradation test completed.
Assist Systems - Self Test Codes
• ISD-W - A self-test warning condition exists. See ISD Setup.
• ISD-F - A self-test warning condition persisted for 7 days and resulted in a Failure.
To Next Page
Loading...
Need help?
General
