- Reset the values modified with the indicating and
adjustment module to the sensor-specific basic setting
l Factory setting
- As basic adjustment, but also reset of special
parameters to the default values
2)
l Peak values measured value and temperature
3)
- Reset of the min./max. values of pressure, level and
temperature to the current values
Information:
Because the reset values are nearly sensor-specifc, they are
listed in the operating instructions manual of the respective
sensor.
Reset
Reset?
In this menu item you select the internal arithmetic unit of the
sensor.
With radar, guided microwave and ultrasonic sensors this is
m(d) or ft(d).
For pressure transmitters more comprehensive units are
available. They are described in the operating instructions
manual of the respective sensor in the menu "Basic adjust-
ments".
Unit of measurement
m(d)
The sensor is already set to the ordered national language. In
this menu item you can change the language. The following
languages are available:
l Deutsch
l English
l Français
l Espanõl
2)
Special parameters are parameters which are set customer-specifically on
the service level with the adjustment software PACTware™.
3)
Temperature only with pressure transmitters and ultrasonic sensors.
Unit of measurement
Language
18 Indicating and adjustment module PLICSCOM
Setup
27835-EN-070123
To Next Page
Loading...
Need help?
General
