EasyManuals Logo

Vega VEGAFLEX 80 series User Manual

Vega VEGAFLEX 80 series
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
6 Diagnostics and servicing
VEGAFLEX 80 series • Two-wire 4 … 20 mA/HART
42960-EN-170410
6 Diagnostics and servicing
6.1 Behaviour in case of failure
The instrument permanently monitored by an internal diagnostic
system. If a malfunction is detected, a failure signal will be outputted
on the safety-relevant output (see section "Safe status").
The diagnosis interval is specied in chapter "Safety-related charac-
teristics".
A fault message coded according to the type of fault is outputted. The
fault messages are listed in the operating instructions.
If failures are detected, the entire measuring system must be shut
down and the process held in a safe state by other measures.
The manufacturer must be informed of the occurrence of a dangerous
undetected failure (incl. fault description).
6.2 Repair
The procedure is described in the operating instructions manual. Note
the instructions for parameter adjustment and setup.
The procedure is described in the operating instructions manual. Note
the instructions for parameter adjustment and setup.
Internal diagnosis
Error messages in case
of malfunction
Electronics exchange
Software update

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vega VEGAFLEX 80 series and is the answer not in the manual?

Vega VEGAFLEX 80 series Specifications

General IconGeneral
BrandVega
ModelVEGAFLEX 80 series
CategoryTransmitter
LanguageEnglish

Related product manuals