12
HPS10 PersonalScope
TM
Do NOT perform measurements unless the
battery compartment is closed. The battery
cover should only be removed for the
calibration of the probe 's X10-position.
F When first using the rechargeable
batteries or if the batteries are completely
discharged, the user should charge them
for at least 12 hours before using the unit.
F When the unit is OFF, the charging time
for 800mA/h type batteries will be
approx. 12 hours.
F The “Charge” indication LED on the
front panel will light up when the
batteries are being charged. (see fig.3.0)
The message “Low. bat” will flash in the
bottom right corner of your display when the
batteries need replacement (or charging).
Insufficient battery voltage may entail
erroneous measuring results. (see fig.4.0)
Safety & Warnings
Fig. 4.0
Fig. 3.0
Charge
HPS10_man.pub
page 12
Wednesday, April 03, 2002 09:22
Composite
To Next Page
Loading...
