Need help?Do you have a question about the Velleman Personal Scope HPS10 and is the answer not in the manual?
General| Bandwidth | 10 MHz |
|---|---|
| Channels | 2 |
| Vertical Resolution | 8 bits |
| PC Interface | USB |
| Input Impedance | 1 MΩ |
| Input Coupling | DC, AC, GND |
| Display | 320 x 240 LCD |
| Power Supply | USB powered |
| Trigger Modes | Auto, Normal, Single |
Details FCC compliance for Class B digital devices and potential interference.
Fields for owner name, purchase date, part number, serial number, and software version.
Lists key capabilities like high-contrast LCD, auto setup, and various measurement functions.
Describes optional accessories such as adapters and cases.
Outlines essential safety measures and precautions for using the device.
Explains how to power the Personal Scope using an adapter or batteries.
Identifies and describes the external connectors and control buttons of the device.
Explains the various indicators and information displayed on the device's screen.
Instructions for turning the Personal Scope on and off, including auto power off.
How to adjust the contrast of the device's display for better visibility.
Details on how to configure the screen layout and display elements.
Explains how to access and use the setup menu for various device settings.
Describes the auto power-off function and its settings for power saving.
Details the different display modes available for viewing signals.
Explains how to send data via RS232, including ASCII and Binary modes.
Covers DC, Max, Min, Peak-to-peak voltage measurements.
Explains dBV, dBm, dB, True RMS, and Power (W) measurements.
Instructions for setting the probe to x1 or x10 and calibration.
Explains how to use markers for measuring time intervals, frequency, and voltage.
How to move the signal display using X/Y-pos controls.
How to select between AC, DC, or GND input coupling for measurements.
How to set the ground reference for accurate DC measurements.
Guides users on using the automatic setup for quick and easy measurements.
How to change the vertical scale (voltage per division) of the display.
How to change the horizontal scale (time per division) of the display.
Explains the different trigger modes: Normal, Run, Once, and Roll.
How to set trigger to rising or falling edge of the signal.
How to shift the vertical trigger position to set the trigger level.
How to freeze the displayed waveform on the screen for analysis.
Instructions for storing a screen capture and recalling stored memories.
How to send screen images to a computer via RS232.
Procedure to reset the unit to factory default settings.
Provides solutions for common problems like blank screen, incorrect readouts, and signal issues.
Outlines the terms and conditions of the product's one-year warranty.
Instructions for cleaning and maintaining the Personal Scope.
Lists the technical specifications for the HPS40 model.
Lists the technical specifications for the HPS10 model.
To Next Page
