22
HPS10 PersonalScope
TM
Display
ADJUSTING THE CONTRAST
Short press: Maximum contrast.
Long press: Change the contrast.
Keep pressing the ‘Contrast’-key to change the
contrast. Release the button at the desired
setting.
DISPLAY SET-UP
Short press: Use the left/right cursorkeys to select one
of the 5 screen layouts. (see fig.10 to 14)
Use the up/down cursorkeys to view/hide the markers,
grid or crosshair on the screen.
• A grid divides the screen into reference
points. (Fig. 12)
• A cross inserts a coordinate system into the
screen. (Fig. 13)
• Markers: Moveable markers in order to
measure the signal (Fig. 14).
Notes:
· The number of readout-digits depends on the
selected display layout.
· At dynamic display mode (see display setup),
the display layout changes for best fitting by
shifting the markers or x-position.
· When no markers are displauyed, the cursor
keys are set for changing the time base or input
sensitivity when no keys are pressed during 10
seconds.
· Markers can also be accessed directly by
pressing the ‘Marker 1-2’ key.
Fig 10 Fig 11
Fig 12 Fig 13
Fig 14
Display
Setup
HPS10_man.pub
page 22
Wednesday, April 03, 2002 09:22
Composite
To Next Page
Loading...
