26
HPS10 PersonalScope
TM
Setup
2. Auto power-off mode
Select the desired off time: 15 minutes, 1 hour
or infinite (no auto power off).
Notes:
· Before power-off, the scope holds the last
screen.
· The auto power-off timer is factory-set to
15min at first power-on or after a reset
· Selecting a slow time base (equal or slower
than 1min/div) will disable the auto power
off.
3. Display mode
Dynamic: The screen layout changes
automatically to show the best signal resolution,
depending on X position shift and the position
of the markers. See also “using the markers”
Manual: The screen layout remains fixed
according to your selection.
Fig 16
3 2
HPS10_man.pub
page 26
Wednesday, April 03, 2002 09:22
Composite
To Next Page
Loading...
