Velleman HPS10 - Page 38

38
HPS10 PersonalScope
TM
1. Press the “Marker 1-2”-key to view, select or
hide the markers. (1)
2. Press the cursur keys to move the markers. (2)
Notes:
• By pressing the ‘Marker 1-2’-key, you
select between marker 1 or 2. The screen
shifts automatically until the selected time
marker is on screen.
• At dynamic display mode (see display set-
up), the best display layout is chosen
depending the use of time markers or voltage
markers.
• Some meter readouts are replaced by the
marker readouts.
• Depending on the chosen display layout, not
all of the marker readouts can be displayed at
the same time.
• Removing the markers from the screen can
be done by repeatedly pressing the ‘Marker
1-2’-key or by a short press of the ‘Display’-
key and using the up/down cursor keys.
Markers
Fig 30
trigger
t-V/div
X / Y-pos
Probe
x1/x10
Memory
Display
setup
ac/dc
Gnd
Auto
Reset
Charge
Slope
Trigger
mode
Marker
1 - 2
1
2
HPS10_man.pub
page 38
Wednesday, April 03, 2002 09:22
Composite