Need help?Do you have a question about the Velleman PCSU200 and is the answer not in the manual?
General| Category | Oscilloscope |
|---|---|
| Channels | 2 |
| Protections | Overvoltage protection |
| Sampling Rate | 1 GS/s |
| Input Impedance | 1 MΩ |
| Input Coupling | DC, AC, GND |
| Timebase | 50 s/div |
| Resolution | 8 bit |
| Power | via USB |
| Frequency | 50/60 Hz |
Lists the essential hardware and OS specifications for installing the software.
Instructions on obtaining the latest PC-Lab200 software version from the Velleman website.
Steps for installing the necessary USB driver for the PCSU200 unit.
Guidance on launching the PC-Lab200 application after hardware and driver setup.
How to select waveforms and set the desired frequency using interface controls.
Details on adjusting the output signal's amplitude level for measurements.
Accessing special waveforms and features via the 'More Functions' button.
Information on the probe test button for oscilloscope probe calibration.
Connecting, starting measurements, and setting voltage/time divisions for display.
How to enable and configure the trigger function for stable waveform display.
Connecting the signal source and observing it on the oscilloscope screen before analysis.
Selecting the appropriate frequency range and channel/volts/div settings for analysis.
Connecting the circuit, selecting settings, and starting the recording process.
How to stop a measurement, perform single screen measurements, and configure auto-save.
Important considerations regarding screen display differences and missed events during recording.
Enabling the Circuit Analyzer and connecting the scope and generator to the circuit under test.
Adjusting Bode plot parameters, generator output, and starting the measurement.
To Next Page
