Velodyne CHT-R SERIES User Manual

www.velodyne.com
8 - CHT-R Series User’s Manual
INTERCONNECT CABLES
When installing your new Velodyne subwoofer using the line-level connections, you should always use shielded
phono cables. There are many decent cables available today, most any of which will work perfectly well. We do
recommend that you keep the length of cable as short as possible to avoid any potential noise problems.
When using speaker level connections, use a quality speaker cable that mates well with the connectors (at least
14-gauge). Be very careful to avoid any loose or frayed strands that could result in a short, causing a dangerous
condition and possible damage to your unit. Cables of extremely large size are typically not required. Extremely
large gauge wire may not properly t in the binding posts, resulting in a poor connection and possible short
circuits.
Placement
True subwoofers operate at extremely low frequencies, which are primarily omni-directional. While it is
recommended that the subwoofers be placed on the same plane as the satellitespeakers, room and system
conditions often dictate otherwise. Keep in mind that frequency response and output level can be drastically
inuenced by placement, depending on the acoustic properties of your listening room. Typically, the optimum
location for a subwoofer is in a front corner of your listening room. This location will usually oer the greatest
output levels and optimum low frequency extension. The worst location for a subwoofer is typically far away
from any walls, close to the center of your room and near an opening or door way. Avoid these locations when
possible. When using a pair of Velodyne subwoofers in stereo, it is preferable to place each subwoofer near the
satellite of the same channel. Typically, a minimum distance of one to two feet from your TV to the subwoofer
will be adequate to avoid anymagnetic interference.
Caution!
This subwoofer has electronics built into the cabinet. Do not place the cabinet next to sources of heat
such as furnace registers, radiators, etc. Do not place the unit near sources of excessive moisture, such
as evaporative coolers, humidiers, etc. The power cord should be routed in such a way that it will not
be walked on, pinched, or compressed in any way that could result in damaging the insulation or wire.

Velodyne CHT-R SERIES Specifications

General

Brand	Velodyne
Model	CHT-R SERIES
Category	Subwoofer
Language	English