Rain sensor
When the rain sensor is acti-
vated, the roof window will close
automatically within approx.
30 seconds.
The rain sensor prevents the
roof window from opening for as
long as it detects rain.
The window can be opened
again with the wall switch when
the rain sensor is dry.
Overruling rain sensor function
The following only applies to VELUX INTEGRA
®
roof windows with a "K" in the size code on the data plate and can only be
carried out with wall switch KLI 311.
Note: Does not apply to VELUX INTEGRA
®
roof windows without a "K" in the size code nor to VELUX INTEGRA
®
flat-roof
windows.
To prevent water damage inside the building, the window normally cannot be opened until the rain sensor is dry again.
However, it may, in some cases, take some time for the rain sensor to dry after the rain has stopped. In these cases, the rain
sensor function can be overruled at the owner’s own risk, see below.
The overruling of the rain sensor will enable the window to open 50% for a period of 15 min.
Warning! As the rain sensor function is suspended for 15 min, there is a risk of water damage to the building. Therefore, we
do not recommend overruling the rain sensor if the window is left unattended.
Press OPEN/UP and STOP key
simultaneously for 1 second.
The window can be closed again anytime with a press on the DOWN key.
To Next Page
Loading...
Need help?
General
