Velux KLI 310 - Set-Up of KLI 310;311 to Operate VELUX Electric and Solar Skylights

VELUX
®
23
Set-up of KLI 310/311 to operate VELUX electric and solar
skylights
Important: The wall switch must be the universal KLI 310 or the
model matching the product.
If a non-functional control must be replaced or if the wall switch
cannot find certain products, you can make the products ready for
reistration by manually resetting them to initial factory settings.
Note: Reset products cannot be operated until they have been
reistered in the wall switch again.
1
Make sure that the power to the skylight (VSS/VCS) is turned on.
2
Close the sash by pressing the button closest to the center of the
skylight (A).
3
When the skylight is closed, reset the skylight by pressing and
holding the button closest to the center of the skylight (A) for at
least 10 seconds. The skylight operator will run briefly back and
forth indicating that the skylight is ready to be reistered.
Note: The skylight must now be reistered in the wall switch within
the next 10 minutes.
4
Press the Pair button on the wall switch for 1 second.
5
Press the stop key and then the DOWN key within 3 seconds. This
is only necessary at the initial set-up after installing the skylight.
The skylight can now be operated by wall switch KLI 310/311.