6 VELUX
®
• The wall switch complies with part 15 of the FCC and RSS-247 of
the IC rules. Operation is subject to the following two conditions:
(1) The wall switch may not cause harmful interference, and
(2) the wall switch must accept any interference received,
including interference that may cause undesired operation.
• The wall switch has been tested and found to comply with the
limits for a Class B diital device, pursuant to part 15 of the
FCC rules. These limits are desined to provide reasonable protec-
tion against harmful interference in a residential installation.
The wall switch generates, uses and can radiate radio frequency
enery and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If the wall switch does cause
harmful interference to radio or television reception, which can
be determined by turning the wall switch off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the wall switch and receiver.
- Connect the wall switch into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the wall switch.
• FCC Radiation Exposure Statement: The wall switch complies with
FCC RF radiation exposure limits set forth for an uncontrolled
environment.
• The term "IC:" before the wall switch certification number sinifies
that the Industry Canada technical specifications were met.
To Next Page
Loading...
