Setting up
Resetting the control pad
3
Reset control pad
You are about to reset the control pad to
inital factory settings. This means that
products and personal settings will be
deleted.
Do you want to continue?
1
2
3
2
1
3
VELUX INTEGRA
®
KLR 200
VELUX 101
The control pad can be reset to its initial factory settings if you want to delete all registered products and personal settings and start
afresh.
Note: If you have one control pad only, all products must be reset before you can register them in the control pad again, see the section
If the initial set-up fails. If you have an additional control, you can copy this to the control pad you are resetting instead, see the section
Adding a control.
Tap
to ensure that the con-
trol pad display is on.
Remove the battery compart-
ment lid by pressing the release
button with a screwdriver as
illustrated
1
,
2
.
Press the RESET button on the
back of the control pad with a
pointed object for at least
5 seconds
3
. Replace lid.
In the display screen, tap "Yes"
to confirm that you want to
reset the control pad.
The control pad has now been
reset. To be able to use it, the
products must be registered
again. See the section Initial
set-up.
To Next Page
Loading...
