Velux KLR 200 - Closing Centre-Pivot Windows in Case of Power Failure or Discharged Battery

Operation
Operation without using the control pad
2
2
1
A
A
3
B
B
1
2
VELUX INTEGRA
®
KLR 200
VELUX 36
Closing centre-pivot windows in case of power failure or dis-
charged battery
In case of power failure or discharged battery, you can close your
centre-pivot window manually by disengaging the chain on the venti-
lation flap of the window.
There are two different ways of doing this, depending on window
type, where the ventilation flap can look like
A
or
B
. See below on
how to disengage the chain on the ventilation flap according to your
window type.
The ventilation flap of the window looks like
A
:
1
Disengage the chain by pressing the release clip on the flap
bracket.
2
Remove the flap bracket.
3
Fold the chain as shown, and close the ventilation flap of the
window to ventilation position.
The ventilation flap of the window looks like
B
:
1
Disengage the chain by pressing the release clip on the flap
bracket.
2
Fold the chain as shown, and close the window manually.
When the power has been reconnected or the battery has been
recharged, you must re-engage the chain.
• Open the window manually and unfold the chain.
• Replace the flap bracket if the ventilation flap looks like
A
.
• Run back the chain by pressing the test button on the window
operator briefly.
• Close the window manually.