Instructions for the installer, maintenance
technician and final user
21
3.2 Characteristics of Installation Area
CAUTION: THE MACHINE IS NOT SUITABLE FOR OUTDOOR
INSTALLATION WITHOUT THE OUTDOOR KIT
CAUTION: DO NOT USE JETS OF WATER TO CLEAN VENDOR, DO NOT
PLACE THE VENDOR IN AREAS WHERE JETS OF WATER ARE USED
Environmental conditions for installing vendor
The vending machine must be installed in an area/room where temperature does not
exceed 32 °C or fall below 10 °C, otherwise the electric parts (compressor) could
overheat or malfunction.
The air circulation is very important for the cooling unit, check that there is a 10 cm gap
between the rear of the vendor and the obstacle (wall).
Check that the surface where the vendor is placed supports the weight of the machine.
To Next Page
Loading...
Need help?
General
