3/2002
PC-17
SET-UP AND CODE DESCRIPTION (CONTINUED)
Set Discount Amount
If selection button two is pressed at the “LESS” prompt, the controller will enter the Discount
Amount Option. Upon entry into this program the display will show the current four-digit
discount amount. If selection button one is pressed it will increase or decrease the lowest
discount amount. Pressing selection button three will save the currently displayed setting
and return the user to the “LESS” prompt.
ESS
Over-Ride Mode (Units equipped with optional key switch)
This feature is used to allow you to manually over-ride (via a key switch) pricing, blocking,
low energy operation and discounting. If selection button two is pressed at the “OUEr”
prompt, the controller will enter the Over-Ride Mode. Upon entry into this program the
display will show “FrEn”. If selection button one is pressed it will cycle through the over-ride
setting options as listed below. Pressing selection button three will save the currently
displayed setting and return the operator to the “OVEr” prompt.
OUer
OVER-RIDE SETTING OPTIONS
“FrEn” Enable/Disable free vend (Edit mode Y/N)
“bLCn” Selection blocking over-ride
“nrGn” Low energy over-ride
“dSCn” Discounting over-ride
Over-Ride Free Vend
If selection button two is pressed at the “FrEn” prompt, the controller will enter the Free
Vend Enable Option. Upon entry into this program the display will show the current setting
“FrEn”. Pressing selection button one will toggle between “y” for enabled and “n” for disable.
Pressing selection button three will save the currently displayed setting and return the
operator to the “OVEr” prompt.
rEn
“Y” = Enable free vend.
“N” = Disable free vend.
To Next Page
Loading...
Need help?
General
