3/2002
PC-16
SET-UP AND CODE DESCRIPTION (CONTINUED)
Discount Setting Mode
This feature is used to choose a group of selections that will be discounted, the amount of
discount, and the time when the discount will occur. If selection button two is pressed at the
“dISC” prompt, the controller will enter the Discount Setting Mode. Upon entry into this
program the display will show the “CtL1”. If selection button one is pressed and released it
will toggle through the discount setting mode as listed below. In order to save the setting
press the service mode button or close the outer door. Pressing selection button three will
save the currently displayed setting and return the user to the “dISC” prompt.
dISC
DISCOUNT SETTING OPTIONS
“CtL1” Enable/Disable discount setting
“SdSC” Selection Setting
“Strt” Set start time
“dAY” Set days to time
“Hour” Set time to start (24 hours)
“LESS” Set Discount amount
“StoP” Set stop time
“dAY” Set days to time
“Hour” Set time to start (24 hours)
Note: For “CtL1”, “Strt” and “dAY” setting refer to page PC-13. For “Hour” setting refer to
page PC-12.
Selection Setting
If selection button two is pressed at the “SdSC” prompt, the controller will enter the Selection
Setting Option. Upon entry into this program the display will show the current setting for
selection as “S 1y” for enabled and “S 1n” for disabled. If selection button one is pressed it
will cycle through the valid selections or “ALL”. Pressing selection button three will save the
currently displayed setting and return the user to the “SdSC” prompt.
SdSC
“Y” = Enable selection setting.
“N” = Disable selection setting.
To Next Page
Loading...
Need help?
General
