10
2.13 FUNCTION / MIX ( MIXING )
MIX - MIXING - used to mix between functions for greater control of the model.
1) Press ENTER to see the FUNCTION MENU.
2) Use the +/- KEYS to highlight MIX and press ENTER.
3) Press ENTER to select a setting.
4) Use the +/- KEYS to change the value.
5) Press EXIT to save and return to SYSTEM MENU, press EXIT to return to the
FUNCTION MENU, press EXIT again to Main Screen.
TERMS: EN-ENABLE, ST-STEERING, TH-THROTTLE, AUX-AUXILLIARY,
Throttle Hold allows the Throttle Servo to be set to a percentage of the total travel range.
This is an alternative to using the choke on a gas motor when starting up a model.
This function locks out the normal use of the Throttle until the TH. HOLD button on the
transmitter is pushed again. Make sure the value is only set high enough to idle the motor
during starting and warm up. NOTE: Setting the Throttle Hold value too high may
cause a run away vehicle.
2.14 FUNCTION / TH. HOLD ( THROTTLE HOLD )
1) Press ENTER to see the FUNCTION MENU.
2) Use the +/- KEYS to highlight TH HOLD and press ENTER.
3) Press ENTER to select a setting.
4) Use the +/- KEYS to change the value.
5) Press EXIT to save and return to SYSTEM MENU, press EXIT to return to the
FUNCTION MENU, press EXIT again to Main Screen.
To use this setting while running the model press
the TH. HOLD button located to the left side of
the throttle trigger once. Doing so will enable the
TH. HOLD and put the throttle at the set value. To
release the TH. HOLD press it once more giving
full function to the TH.TRIGGER.
SERVO
LOCATED ON THE RIGHT
SIDE OF THE TRANSMITTER
To Next Page
Loading...
Need help?
General