VENOM VR3T - VR3 T F;S (Fail-Safe); Understanding Fail-Safe Functionality; Setting Fail-Safe Parameters; VR3 T NEUTRAL Calibration

11
The Fail Safe feature is used to help prevent an out of control model caused by the
loss of a transmitter signal. If a loss of signal should occur the receiver will adjust the
steering or throttle or both to a preset value.
This function is used to calibrate the neutral center point of the of the Steering wheel
or Throttle trigger.
1) Press ENTER to see the FUNCTION MENU.
2) Use the +/- Keys to select the NEUTRAL function.
3) Use the +/- Keys to select YES.
4) Press ENTER to calibrate the neutral
5) Press EXIT TWICE to save and return to the FUNCTION menu.
Note: Do not move the Steering wheel or Throttle trigger during the calibration
process.
2.15 FUNCTION / F/S (FAIL-SAFE)
2.16 FUNCTION / NEUTRAL
1) Press ENTER to see the FUNCTION MENU.
2) Use the +/- KEYS to highlight F/S and press ENTER
3) Press ENTER to select a setting
4) Use the +/- KEYS to change the value
5) Press EXIT to save and return to SYSTEM MENU, press EXIT to return to the
FUNCTION MENU, press EXIT again to Main Screen.
1) Press ENTER to see the FUNCTION MENU.
2) Use the +/- KEYS to highlight F/S and press ENTER
3) Press ENTER to select a setting
4) Use the +/- KEYS to change the value
5) Press EXIT to save and return to the FUNCTION MENU, press EXIT again to Main
Screen.
TERMS: EN-ENABLE, TH-THROTTLE, ST-STEERING,
TERMS: EN-ENABLE, TH-THROTTLE, ST-STEERING,