Ventrac 4500Y - Replacing Fuses (Rear Fuse Panel)

SERVICE
Service - 53
Replacing Fuses (Rear Fuse Panel)
1. Park the power unit on a level surface.
2. Engage the parking brake and shut off the engine.
3. Remove the key from the ignition switch.
A
4. Turn the battery disconnect
switch to the Off position.
5. Tilt the seat forward and
fasten in place with the seat
prop.
6. Remove the sealed cover (A)
from the fuse panel.
7. Identify and pull the defective
fuse from the socket.
8.
Rear Fuse Panel (Mini Fuse)
Position Fuse Circuit
1* 25 amp (CB) Spreader
2* 30 amp (CB) Cab
3* 10 amp Spreader Vibrator
4* 20 amp 12v Rear
5* 5 amp Slope Indicator
6* 5 amp 12v Front 1
7* 15 amp 12v Front 2
8* 10 amp Hyd. Aux
9 5 amp Seat Switch Circuit
10 25 amp (CB) Hydraulic Oil Cooler Fan
*Optional accessory.
Insert a new fuse into the socket. Be certain to
use the correct amperage fuse or damage may
occur to the power unit.
9. Reinstall the sealed cover onto the fuse panel and
lower the seat back down to the operating position.
10. Turn the battery disconnect switch to the On
position.
Replacing Fuses (Engine)
1. Park the power unit on a level surface.
2. Engage the parking brake and shut off the engine.
3. Remove the key from the ignition switch and
allow the engine to cool.
4. Turn the battery disconnect switch to the Off
position.
5. Open the engine hood to access the engine
compartment.
6. (Fuse link) Remove fuse link (B) from starter
and alternator and install new fuse link.
7. Locate the fuse holder (A) and pull up on the tab
to remove the cover.
8.
Engine Fuses
Position Fuse Circuit
A 50 amp J-Case Glow Plug
B 80 amp fuse link Charge
B
A
Pull the defective fuse from the socket.
9. Insert a new fuse into the socket. Be certain to
use the correct amperage fuse or damage may
occur to the power unit.
10. Reinstall the fuse cover.
11. Close the engine hood and turn the battery dis-
connect switch to the On position.