Need help?Do you have a question about the Verdant VX-TR and is the answer not in the manual?
General| Brand | Verdant |
|---|---|
| Model | VX-TR |
| Category | Thermostat |
| Language | English |
Screw antenna onto receiver, connect receiver to server via USB, fix receiver to wall. Orient antenna for best signal.
Connect the server to the LAN port using the supplied RJ-45 cable for network access.
Plug the server into an electrical outlet with the supplied power cord. Connect to a UPS for reliability.
Connect the Network Programmer to the thermostat's T-shape opening and press the black button to initiate programming.
Power off HVAC unit, connect wiring harness to wall wires, then plug harness into thermostat. Refer to wiring tables.
Remove cover, use anchors/screws to secure thermostat, follow configuration instructions, then replace cover.
Set the thermostat clock to the current time using the 'Up'/'Down' buttons for hours/minutes and 'Fan' to advance.
Enter the room number by changing digits on the screen using 'Up'/'Down' buttons and 'Fan' to advance to the next digit.
Set the compressor type by changing the first digit on the thermostat screen (0=None, 1=Heat Pump, 2=AC).
Configure electric heat settings by changing the second digit on the thermostat screen (0=No, 1=Yes).
Set the reversing valve by changing the third digit (0=Cool, 1=Heat). Consult PTAC docs for correct setting.
Select an energy saving preset (0-5) using the 'Up'/'Down' buttons to adjust energy saving levels.
To Next Page
