Vericom VC4000 - GPS not working (PC)

VC4000 Manual
102
Troubleshooting
Unit is
unresponsive to
keypad
 Program is locked up. Short pins 1 and 2 of
the external activation input to reset it. See if
updated firmware is available.
Power is on but
display is blank
 Press the CLEAR / NO key on the keypad.
Sudden voltage swings can cause this.
GPS not
working (PC)
 GPS not on: Turn GPS speed on in Setup.
 RS232 port not selected: Set GPS RS232
port to 1.
 May take up to 1 minute to acquire satellites.
FLASH-ERROR
 There was a problem writing to the flash
memory. Import data to Profile if necessary
and clear memory
RUN-FILE-FULL
 Memory is full. Import data to Profile if
necessary and clear memory
RUN-FILE-LEN
 File is too long for memory capacity
ARITHMETIC
EXCEPTION
 Divide by 0 error. Power off and back on