Veridian 01-5021 - Troubleshooting & Error Codes

ENGLISH – 21
Problem Possible Cause Solution
Troubleshooting - Error Codes
If an error code persists or is not remedied, please contact
Customer Care at 866-326-1313.
Display Shows Er 1
Display Shows Er 0
Display Shows Er 2
Display Shows Er 3
Display Shows Er 4
Display Shows Er 5
Display Shows Er 6
Display Shows Er 7
Display Shows Er 8
Display Shows Er A
Review the ‘Taking a Measurement’
portion of the manual, wait a
minimum of 5 minutes and attempt a
new measurement.
Review the Applying Cuff portion of
this manual; re-apply the cuff, wait a
minimum of 5 minutes and attempt a
new measurement.
Check that the cuff is applied properly,
wait a minimum of 5 minutes and
attempt a new measurement. If the
monitor still does not perform or
performs abnormally, contact
Customer Care
Pressure system is unstable
before measurement
Failed to detect systolic pressure
Failed to detect diastolic
pressure
Pneumatic system blocked or
cuff is too tight during ination
Pneumatic system leakage or
cuff is too loose during ination
Cuff pressure above 300 mmHg
Cuff pressure above 15 mmHg
for more than 3 minutes
EEPROM accessing error
Device parameter checking
error
Pressure sensor parameter
error