July 25, 2013
3 SOFTWARE INSTALLATION
Before you begin
The following is required near the end of the installation.
■ Make sure to have a piece of paper and writing utensil to record the user
name, secure user ID, and password that will be displayed on the screen.
■ Name of the Installer
■ IP address for the Security Log Server. Up to 4 may be defined (or enter
‘none’).
■ Make note of the time zone
Download Software
Download the Commander Site Controller Suite Software file from the VASC
portal. The Commander Site Controller software is installed from a PC with the
appropriate software stored on its hard drive or on a CD.
The Commander Site Controller software suite contains three files:
■ Executable Jar File (Petro_Suite_Installer.jar)
■ ZIP File (overlay.zip)
■ Signature File (overlay.sig)
■ Import/Export Utility
Connections
When installing the software on the Commander Site Controller from the PC,
both must be connected to the LAN side of the same router via Ethernet cables
(both should be connected within the “VeriFone zone”).
The Ethernet cable should be connected to the Net LAN port on the Commander
Site Controller in the slot labeled “N”.
To Next Page
Loading...
Need help?
General
