VeriFone e285 - Page 5

Connect to your network
1. From the list of networks, tap the network you want to connect to.
2. Tap Add.
3. Select the type of authentication that your network uses. If you don’t know the type of
authentication your network uses, contact your network administrator.
4. Enter your network details. The details you need to enter depend on whether you chose
pre-shared key (PSK) authentication or extensible authentication protocol (EAP) authentication.
a. For PSK authentication, in the Pre-Shared-Key (PSK) field, enter the authentication
password.
b. For EAP authentication, enter the following:
i. Identity
ii. Password
Note: For information about how to enter a special character, go to the FAQs section.
5. Tap OK.
6. Tap Save, and then tap OK.
7. Tap Yes.
8. Tap OK.
Apply your settings and return to the home screen
1. Tap .
2. Tap Exit, and then tap Yes.
3. Tap the Genius icon.
Bluetooth
Important: By default, Bluetooth connection isn’t enabled on your e285. To enable
Bluetooth connection, contact our Support Team.
1. Turn on your e285. You must connect your e285 to your POS within 180 seconds. If you don’t
connect your e285 to your POS within 180 seconds, you must restart your e285.
2. Follow the instructions on your POS to connect your e285 to your POS.
5 | Wireless e285 Quick Start Guide