Ruby2 Hardware Installation Guide
8 October 01, 2013
Diagnostic Panel
The Diagnostic Panel is located on the right side of the Ruby2 and can be
accessed by loosening the screw that holds the cover in place. From left to
right, this panel contains the following:
■ Reset Button: Reboots the Ruby2 workstation without shutting
down the power.
■ Diagnostic Switch Panel: Used to configure specific operating
modes. Do not change settings unless instructed by the VeriFone
Technical Support Center.
■ Console Port: Used only by the VeriFone Authorized Service
Contractor (VASC).
■ System Heartbeat LED: Pulses on and off to indicate that the
Ruby2 is operating normally.
■ Status Window: Displays system operating codes.
To Next Page
Loading...
Need help?
General
