Table of Contents
PaymentCloud LLC. • 800-988-2215 • support@paymentcloudinc.com
Additional Information
Spec Sheet
Shop Verifone V200C
V.032025 4
Verifone V200C
User Manual & Setup Guide
Connect to Ethernet (Static IP)
Connect to WiFi
How to Set Up an Ethernet or Wifi Connection
1. Link your Ethernet cord to the V200c’s Ethernet port.
2. Route Ethernet cord to network jack.
3. Log in on your Verifone V200c by selecting the SUPERVISOR
option. Following this, enter your supervisor password.
4. Select COMMUNICATION.
5. Select CONFIGURATION.
6. Select NETWORK INTERFACE.
7. Select LAN.
8. Enable AUTOSTART, then conrm.
9. If prompted, enter your device’s IP address, then conrm.
Note: Improper use of your V200c Ethernet cord could potentially
damage or impair your Verifone device.
1. From the main menu, select COM CONTROL.
2. Under COMMUNICATION PANEL, you will see a list of
connection options: LAN, DIAL-UP, WIFI, etc. Select WIFI.
3. Select CONFIGURATION.
4. Slowly enter the following password when prompted: 20331.
5. Select WIFI SCAN.
6. Your device will start to scan for available WiFi networks.
7. When presented with a menu of network options, select your
home network, then conrm.
8. You will then manually enter your network password or select
the pre-saved key option for your password details.
9. To nalize, select SAVE.
Setup Cont.
Setup
3
Accept Payments
5
Rights Reserved
11
Settings
8
Troubleshooting
& Tips
9
Overview
2
To Next Page
Loading...
