14 15
Note: If you touch the control again before the completion
of the three pulses, you will be able to continue to modify
the session time.
Stopping the Timer
Touch and hold the timer control until the illuminated lights
turn off. If you would also like to turn off the light, press the
on/off button at the top of the lamp to turn the power off
completely.
How to Use - Controls • continued
Customizing the Length of Your Session
You can customize the length of your light therapy session
in 10 minute increments.
Step 1 - Touch and hold your finger on the timer control
located on the base of the light for 2 seconds. The
illuminated increment lights will pulse twice indicating that
programming mode has begun.
Step 2 - Continue to hold your finger on the control and
select the length of your light therapy session. The amount
of time is indicated for each light.
Step 3 - Remove your finger when the desired time has
been illuminated. The illuminated lights will pulse three
times to recognize the chosen session time and indicate
that the programming mode has been completed.
How to Use - Controls • continued
VT52_MAN_Rev2.indd 14-15VT52_MAN_Rev2.indd 14-15 9/10/20 8:36 PM9/10/20 8:36 PM
To Next Page
Loading...
Need help?
General
