8
Using the Rise & Shine: Controls
1. LCD Display
2. Light Brightness Buttons
The Up and Down light brightness buttons
function
when using the Rise & Shine
®
as a lamp or as a sunset/
sleep cycle simulator. To operate in lamp mode,
press the top of the Rise & Shine — as you would a
button. The light will go to the level at which it was set
previously: You may use the Up and Down buttons
to change the desired light level. To turn off the lamp,
simply press on the top as you did to turn it on or press the “Off” button
Off
.
See “Setting the Sunset/Sleep Cycle Simulator” on page 12 for instructions on
how to set the lamp brightness in a sunset/sleep cycle simulation.
You will use a different procedure to set the light level when you’re programming
a wake-up alarm. See pages 10–11.
3. Volume Buttons
Use the Volume buttons
to set the radio or
soundscape volume when operating either one
manually. (See #s 4 and 5 in this section.)
There is a different procedure for programming the
wake-up volume when setting an alarm or sleep cycle.
See Section Programming the Rise & Shine on pages 10–11.
4. Sound Button
You can play any of the four soundscapes at any time
by pressing the Sound
Sound
button. Use the or
button to select the desired soundscape. Use the
Volume buttons to set the volume.
Press the Sound
Sound
button or the Off
Off
button to
turn off the soundscape.
Natural Soundscape Icons
Real-Time Clock
FM Frequency
Alarm 1 Icon
Alarm 2 Icon
Sleep Delay
Time Icons
Audio Light
VA05F-MAN-Rev19.indd 8 8/3/12 3:03 PM
To Next Page
Loading...
Need help?
General
