Verint S5020BX-DN User Manual

All users should read the related user manuals for complete details on installation, usage and functionality.
Quick Installation Guide
S5000 Series - BX Models
Version 1.0
Nextiva
1
Hardware Overview
The Nextiva S5000BX is available in two models S5003BX-DN and S5020BX-DN. The S5003BX-DN
features a VGA sensor and the S5020BX-DN features a 2-Megapixel sensor.
Lens are not included with the camera, but Verint offers multiple lenses that are available for purchase. If
you choose to purchase a lens elsewhere, ensure it has the following characteristics:
 Aspherical
 CS mount, 1/3 inch format
 Manual or DC auto iris
 Day/Night support
Light Sensor
Built-in
Microphone
SD/SDHC
Card Slot
Audio/Video out,
1/8in (3.5mm) jack
Status LEDs
External
Microphone In
12V DC
Power Cord
Connector
NTSC/PAL
Switch
External/Internal
Mic Switch
RJ-45 Network
Connector
DC-Iris Control
Cable Connector
Hardware Reset
Button
12V DC Output
Relay Output
Dry Contact Input
Ground
24V AC Input
RS-485 +
RS-485 -
Focus Controller*
Zoom Controller*
Auto Iris Cable
Front View Rear View
*The position of the zoom and focus controllers will vary depending on
the lens manufacturer.

Verint S5020BX-DN Specifications

General

Model	S5020BX-DN
Category	IP Camera
Form Factor	Bullet
Focal Length	2.8 - 12 mm
Aperture	F1.4
Network Interface	10/100 Mbps Ethernet
Power Supply	12V DC
Ingress Protection	IP66
Weather Resistance	Yes
IR Range	Up to 30 m (98 ft)
Resolution	1920x1080 (Full HD)
Minimum Illumination	0.01 Lux
Day/Night	Yes
Video Compression	H.264
Frame Rate	30 fps
Power over Ethernet	PoE (802.3af)
Sensor Type	1/2.8" progressive scan CMOS

Summary

Hardware Overview

Front View

Details the components and features visible on the front of the Nextiva S5000BX camera.

Rear View

Describes the various ports, connectors, and indicators located on the rear of the camera.

Installing the Nextiva S5000BX Models

Mounting the Lens

Instructions on how to properly attach a compatible lens to the camera mount.

Setting the Video Standard

Guide on selecting the video output standard (NTSC or PAL) for the camera.

PoE Power Connection

Steps for powering the camera using an 802.3af compliant Power over Ethernet (PoE) kit.

12V DC and 24V AC Power Connections

12V DC Power Connection

Procedure for connecting the camera to a 12V DC power supply.

24V AC Power Connection

Procedure for connecting the camera to a 24V AC power supply.

Setting the IP Address

Using SConfigurator

Instructions for downloading and using the SConfigurator tool to set the camera's IP address.

Adjusting the Field of View and Focus

Lens Adjustment Procedure

Steps to adjust the camera's zoom factor and focus range using external controllers.