Veripos HEXAGON LD8 - Page 27

Configuration and operation
LD8 Operations Manual 27
Enabling VERIPOS RTCM output via terminal
RTCM can be output on any of the LD8 serial COM ports. Within the terminal window enter the commands
below where updating COM1 with the desired output COM port number.
UNLOGALL COM1
INTERFACEMODE COM1 NONE RTCM OFF
LOG COM1 VERIPOSRAWRTCMDATAB ONNEW
To change the baud rate of the serial port, send command below. COM should be the same COM port as used
in the initial step and the field 9600 replaced with the appropriate baud rate.
SERIALCONFIG COM1 9600 N 8 1 N ON