Introduction
LD8 Operations Manual 4
1.5 Activating VERIPOS correction services
VERIPOS correction signals are provided as a chargeable service. In order for the LD8 to decode corrections and
output a corrected position, it must be activated. The user can send a request for an activation of services to the
VERIPOS Helpdesk and the activation will then be sent via L-band satellite to the requested unit.
When not in use, some service agreements may allow for deactivation of the service. The activation/deactivation
procedure is detailed in section Activation and deactivation of VERIPOS services.
To use VERIPOS correction signals a contract between the users’ company and VERIPOS must be in place.
VERIPOS call this a Service Access License (SAL).
To avoid delays users should record the SAL number associated with the VERIPOS equipment.
The VERIPOS Helpdesk are unable to activate any equipment unless an active SAL exists, and its reference
number can be determined.
To Next Page
Loading...