Need help?Do you have a question about the VERITAS 5250 and is the answer not in the manual?
General| Serial ports quantity | 1 |
|---|---|
| Ethernet LAN (RJ-45) ports | 6 |
| USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity | 3 |
| Ethernet LAN | Yes |
| Cabling technology | 10/100/1000Base-T(X) |
| Ethernet interface type | Gigabit Ethernet |
| RAID levels | 6, 1 |
| Optical drive type | No |
| Supported HDD sizes | 2.5, 3.5 \ |
| Total storage capacity | 140000 GB |
| Maximum storage capacity | - TB |
| Power supply | - W |
| Power supply input voltage | 100 - 240 V |
| Power consumption (typical) | 240 W |
| Power supply input frequency | 50 - 60 Hz |
| Operating temperature (T-T) | 10 - 35 °C |
| Memory slots | 16x DIMM |
| Internal memory | - GB |
| Internal memory type | DDR4-SDRAM |
| Maximum internal memory | 512 GB |
| Operating system installed | - |
| Processor cache | 16.5 MB |
| Processor cores | 12 |
| Processor model | 4214 |
| Processor frequency | 2.2 GHz |
| Processor manufacturer | Intel |
| Processor boost frequency | 3.2 GHz |
| Number of processors installed | 2 |
| Chassis type | Rack (1U) |
| Product color | Black |
Weight and Dimensions| Depth | 769 mm |
|---|---|
| Width | 482.6 mm |
| Height | 89 mm |
| Weight | - g |
Provides recommendations for installing hardware into a rack for optimal performance and safety.
Provides step-by-step instructions for installing storage shelf rack rails into a cabinet.
Guides users on how to physically install the storage shelf into the prepared rack rails.
Provides step-by-step instructions for installing D Series storage shelf rack rails into a cabinet.
Guides users on how to physically install the D Series storage shelf into the prepared rack rails.
Details the process of installing the appliance's own rack rails for mounting.
Guides users on how to mount the appliance into the rack using the installed rails.
Provides instructions for connecting the appliance to a single D Series storage shelf.
Details the procedures for connecting the appliance to multiple D Series storage shelves.
Details how to connect the AC power supplies for redundancy and ensure proper operation.
Guides users on the correct sequence for powering on components and verifying system operation.
Explains how to configure the IPMI port using the NetBackup Appliance Shell Menu.
Explains how to install the expansion storage kit components, such as DIMMs, into the appliance.
Describes how to connect S Series storage shelves to an appliance, covering various quantities.
Describes how to connect D Series storage shelves to an appliance, covering various quantities.
Explains how to move the MSDP partition to an expansion disk for better performance.
To Next Page
