VERITAS NetBackup 5230 User Manual

■ Add the name of this media server to the master server that you plan to use
with it.
■ If a firewall exists between the master server and this media server, open the
appropriate ports as described in the link above.
■ Make sure that the date and time of this media server matches the date and
time on the master server.
The following procedure describes how to configure a new or a re-imaged appliance
from the NetBackup Appliance Web Console.
Caution: Before or immediately after initial configuration, change the default
maintenance password (P@ssw0rd) for the appliance. This password must be
provided to Veritas Technical Support in case you need future troubleshooting
assistance. Change the maintenance password through the NetBackup Appliance
Shell Menu with one of the following commands: Main > Settings > Password
maintenance or Main > Support > Maintenance > passwd. For complete
information, see the NetBackup Appliance Command Reference Guide.
To perform the initial configuration on a NetBackup 52xx appliance from the
NetBackup Appliance Web Console
1
On the laptop that is connected to the NIC1 appliance port, navigate to the
Local Area Connection Properties dialog box.
On the General tab, select Internet Protocol (TCP/IP) so that it is highlighted,
then click Properties.
32Initial configuration procedures
Performing the initial configuration on a NetBackup 52xx appliance from the NetBackup Appliance Web Console

VERITAS NetBackup 5230 Specifications

General

Language version	-
License type	Corporate
License quantity	- license(s)
License term in years	1 year(s)