■ If the master server is a traditional (non-appliance) NetBackup master
server:
2
Log in to the master server as the administrator and add the media server
name to it as follows:
From the NetBackup Appliance Web Console:
■ Click Manage > Additional Servers > Add.
■ In the Appliance Hostname field, enter the fully
qualified host name (FQHN) of the appliance media
server that you want to add.
■ Click Add.
If the appliance has more than one host name, you
must add all of the names.
From the NetBackup Appliance Shell Menu:
■ From the Main_Menu > Settings view, run the
following command:
Settings > NetBackup AdditionalServers
Add media-server
Where media-server is the fully qualified host name
(FQHN) of the appliance media server that is not yet
configured.
If the appliance has more than one host name, you
must add all of the names.
For an appliance master
server:
■ Log on to the NetBackup Administration Console as
the administrator.
■ On the main console window, in the left pane, click
NetBackup Management > Host Properties >
Master Servers.
■ In the right pane, click on the master server host
name.
■ On the Host Properties window, in the left pane,
click Servers.
■ In the right pane, in the Additional Servers section,
click Add and enter your appliance host name. The
appliance host name should appear in the top
Additional Servers section.
If the appliance has more than one host name, you
must add all of the names.
■ Click OK and close the Master Server Properties
window.
For a traditional NetBackup
master server:
58Initial configuration procedures
Configuring a master server to communicate with an appliance media server
To Next Page
Loading...
Need help?
General
