Safety
Palm is FCC approved, complying with Specific Absorption
Rate (SAR) standards, making it safe to use.
Dispose of the device properly. Materials in the device may
not be safe for landfills. Law requires that you recycle your
device at a designated electronic waste location.
Limitations
No device can be used or sold in Cuba, Iran, Syria, Sudan, or
North Korea.
Radio waves
THIS MOBILE PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your mobile phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits
for exposure to radio-frequency (RF) energy. These limits are
part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The guidelines
are based on standards that were developed by independent
scientific organizations through periodic and thorough
evaluation of scientific studies. These guidelines include a
substantial safety margin designed to ensure the safety of all
persons, regardless of age and health.
The exposure standard for mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by public authorities such as the Federal
Communications Commission of the US Government (FCC), or
by Industry Canada, is 1.6 W/kg averaged over 1 gram of body
tissue. Tests for SAR are conducted using standard operating
positions with the mobile phone transmitting at its highest
certified power level in all tested frequency bands.
This device is complied with SAR for general population
/uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and
had been tested in accordance with the measurement
methods and procedures specified in IEEE1528.
The FCC has granted an Equipment Authorization for this
model phone with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR
information on this model phone is on file with the FCC and
can be found under the Display Grant section of
www.fcc.gov/oet/ea/fccid after searching on FCC ID:
2AOETPVG100.
Although the SAR is determined at the highest certified power
level, the actual SAR level of the mobile phone while operating
can be well below the maximum value. This is because the
mobile phone is designed to operate at multiple power levels
so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station antenna,
To Next Page
Loading...
