MP10
Assembly Instructions (5 or 7 Panels)
Reserve Materials Take out and set aside 4 part B, 4 part D and the 2 canvas end
panel covers with Velcro tabs.
Layout fi rst plain canvas panel, Velcro closure facing up. Insert 2 part D, one for each side.
Connect the panel frame posts with 2 of part A, facing the two plain ends the same direction.
Use 4 Screws on the inside of corners to secure the frame. Pull canvas ends taut and seal
Velcro fl aps to fi nish your outside panel.
Hardware included:
A
A
D
D
Panel Assembly - Step 1
1.
2.
Screws Wheels End
Panel
Plates
Hinge
Plates
Parts included:
A - Outside Panel Frame Caps (4)
B - End Panel Frame Caps (4) C - Center Panel Frame Caps
(8) 5-panel or (10) 7-panel
D - Panel Frame Posts (10) 5-panel or (14) 7-panel
Canvas panel covers (5) 5-panel or (7) 7-panel
(2 with Velcro Tabs are for end panels)
Panel Assembly - Step 2
Panel Assembly
1
To Next Page
Need help?
General
