VersaTables FB Series

To Next Page

14105 Avalon Boulevard, Los Angeles, CA 90061 | Tel 800-465-1660 x1 | Fax 310-353-7109

www.Versatables.com

Foundry Bench Assembly Instructions

REV 04082022

FB Series 48” & 60”

MADE IN

AMERICA

How can we improve our assembly instructions?

Your comments and suggestions are important to us.

Please e-mail us at: engineering@versaproducts.com

Main Page

Need help?

Do you have a question about the VersaTables FB Series and is the answer not in the manual?

Summary

Foundry Bench Assembly

Leg Uprights and Back Panel Installation

Attaching leg uprights to feet and installing the back panel to the uprights.

Casters and Moving Beams Setup

Installing casters into feet and attaching moving beams to leg uprights.

Actuator Installation

Securing the lifting actuators to the frame components.

Surface Panel Attachment

Mounting the front panel and the primary top surface to the assembly.

Support and Electronics Integration

Installing the cross support and the USB switch module.

Bottom Surface and End Caps

Attaching the bottom surface and finishing the frame with end caps.

Cable Management and Connection

Connecting actuators and organizing cables using holders.

Foundry Bench Wiring Diagram

Sit to Stand Keyboard Arm and Tray Add-on

Parts Identification

Lists the parts required for the keyboard arm and tray add-on.

Keyboard Arm and Tray Assembly

Instructions for attaching keyboard brackets and mounting the tray or keyboard.

CPU Holder Add-on

CPU Holder Tools and Parts

Lists required tools and components for the CPU holder attachment.

CPU Holder Assembly Steps

Step-by-step guide for attaching the CPU holder to the desk frame.

CPU Holder Adjustability

Details on adjusting the height and width of the CPU holder.