VX-450 SerieS Operating Manual
10
Before you BegIn
Battery Pack Installation and Removal
r
To remove the battery, turn the radio off and re-
move any protective cases. Slide the Battery Pack
Latch on the bottom of the radio toward the front
panel while sliding the battery down about 1/2
inch. Then lift the battery out from the radio.
Do not attempt to open any of the re-
chargeable Lithium-Ion packs, as they
could explode if accidentally short-circuited.
r
To install the battery pack, align the battery pack
to the radio with an offset about 1/2 inch from the
top edge of battery compartment, then slide the
battery pack upward until it locks in place with a
“Click.”
WARNING
The IS version of the
VX-450
series is only intrinsically safe with the use of the
FNB-V113LIIS
Battery
Pack. To acquire the IS version of the
VX-450
series you much select the Intrinsically Safe battery option
at the time of purchase. Replacement
FNB-V113LIIS
batteries may also be purchased however to be con-
sidered IS the radio must have originally been purchased with the IS battery option.
Do not reverse-connect the battery terminals.
Do not parallel-connect the battery terminals.
Do not charge batteries in hazardous locations.
To reduce the risk of explosion, recharge the batteries outside of hazardous locations.
To Next Page
Loading...
Need help?
General
