Vertex Standard VXR-7000 Operating Manual

VXR-7000 FM REPEATER OPERATING MANUAL 13
TX Pwr: Transmitter Power Output Selection
This parameter selects the desired power output from
the VXR-7000 on the current channel. The available val-
ues are HIGH and LOW.
Press the [SPACE] bar to select “Hi” or “Lo.”
TOT Mute: Enable/disable the TOT (Time-Out Timer) beep
monitoring
When this parameter is set to “on,” the alert beep will
sound from the front panel speaker before the repeater
turns itself off.
RptTOT Use: Enable/disable the Time-Out Timer while op-
erating in the repeater mode
Press the [SPACE] bar to toggle the Repeater TOT selects
“yes” or “no.”
The TOT time is determined via dealer programming.
RptTOT Beep: Enable/disable the TOT beep Transmission
Press the [SPACE] bar to toggle the TOT beep selects “ yes”
or “no.”
When this parameter is set to “yes,” the alert beep will
be sent out on the air before the repeater turns itself off,
while oprtating in the “REPEATER” mode.
RPT HT: Enable/disable the Repeater Hang-on Timer
Press the [SPACE] bar to toggle the Repeater Hang-on
Timer selects “yes” or “no.”
When this parameter is set to “yes,” the repeater will
remain keyed for a desired seconds after a receiving
carrier is dropped.
The Hang-up time is determined via dealer program-
ming.
RPT GT: Enable/disable the Repeater Guard
When this parameter is set to “yes,” the transmitter in-
hibit few second before the repeater is unkeyed.
The inhibit time is determined via dealer programming.
CE27 Programming Software Instruction

Vertex Standard VXR-7000 Specifications

General

Brand	Vertex Standard
Model	VXR-7000
Category	Repeater
Language	English