Vertex
FTL-1011, FTL-2011
&
FTL-7011
Operating Manual
when the transceiver is turned off, or when scanning is disabled (by
pressing the
SCAN
button again, so that a channel number is dis-
played). The
SCAN
modes and their corresponding displays are as
follows:
Display Scanning Function
Sc
Scan all channels
U
r
Scan only user-selected channels
SP
Monitor one channel and pre-programmed priority(ies)
UP
Scan user-selected channels with user priority(ies)
The user-selected channels for the
Ur
and
UP
modes are those
you can set yourself, as described
in
the box on the next page. The
priority channels are those on which signals will take priority over
signals received on other channels: that is, if a signal appears on a
priority channel while another appears on a non-priority channel,
the priority signal will be heard, and not the other. Up to two of the
installed channels may be designated by your network administra-
tor or dealer as pre-programmed priority channels for the
SP
mode
(the radio does not indicate which they are), and you can program
any two channels as user priorities for the
UP
mode. The non-pri-
ority channel in the
SP
mode is the one last displayed.
While a scan mode is displayed, you can select another by
pressing the
PRI
button repeatedly (the display will cycle through
the above). Make sure the microphone is in its hanger if you want
scan
catoi
chan
or wher
:he displ
.,&*A
c,
1.
-.
1
scannir
lay
may
.A
;--l..A
p
(p
1)
t?
E
(Scan Enable) Indic
Jhen a channel number is displayed, either during manual
ning) operation, lg is pau
i
indi-
rs at
the
top of
t
be lit.
TT
at the
~nel has been seleLLCU
LV
VC
IILLILLJed in uscl
scalLlL11L6
llrvc~es
(Ur
and
UP).
If the
P
indicator is blinking
nnel is the 1st (highest
priority) channel for the
UP
mode.
If
tl
)t blinking but steadily
on, the channel is the 2nd priority
C~I~I~II~I.
30th priority channels
serve as ordinary user-selected scan channels in the
Ur
mode.
,
the cha
le
P
is nc
..
1
1
P
and
E
licate th
(non-
To Next Page
Loading...
Need help?
General
