150
-VERTIGO COMBAT-V07-ENG.DOCX - ELECTRICAL SECTION
Carrer Argenteria 8-10, Pol. Ind. Riera de Caldes. 08184 Palau-Solità i Plegamans (Barcelona - Spain) T + 34 931 70 16 55.
5 ELECTRICAL SECTION
5.1 Specific safety guidelines
• Ensure that the battery terminals do not touch the motorcycle frame as this may cause a short circuit or spark, which would ignite battery gases
causing a risk of personal injury. Do not attach jump leads to the battery, touch the battery cables together or reverse the polarity of the cables as any
of these actions may cause a spark which would ignite battery gases causing a risk of personal injury.
• The bulbs become hot during use. Always allow sufficient time for the bulbs to cool before handling. Avoid touching the glass part of the bulb. If the
glass is touched or gets dirty, clean with alcohol before re-use.
• Always replace blown fuses with new ones of the correct rating (as specified on the fuse box cover) and never use a fuse of higher rating.
• Under some circumstances, the battery can give off explosive gases; keep sparks, flames and cigarettes away. The battery contains sulfuric acid
(electrolyte). Contact with skin or eyes may cause severe burns. Wear protective clothing and a face shield.
• Ensure the electrolyte container part number matches the battery part number to be filled. Battery life will be greatly reduced if the incorrect volume
(either too little or too much) of acid is added to the battery.
• Never attempt to adjust a headlamp beam when the motorcycle is in motion. Any attempt to adjust a headlamp beam when the motorcycle is in
motion may result in loss of control and an accident.
• Do not reconnect the battery until the assembly process has been completed. Premature battery reconnection could result in ignition of the battery
gases causing risk of injury.
• When disconnecting a connector, never pull directly on the wires as this may result in cable and connector damage.
• Damage to the connector pins may result if an attempt to fit the connectors incorrectly is made.
• Ensure that the beams are adjusted to illuminate the road surface sufficiently far ahead without dazzling oncoming traffic.
• When installing the lens, ensure that the locating tang is correctly aligned to the indicator body.
To Next Page
Loading...